p hihong ? s 150w c onstant c urrent d rivers with 94% e fficiency p rovide t ruly a dvanced p erformance output voltage output current output power 0v~425v 0.35a 150w 0v~280v 0.53a 150w 0v~210v 0.7a 150w 0v~140v 1.05a 150w 0v~100v 1.5a 150w 0v~89v 1.68a 150w
pda150w series brand name phihong led driver description 150w, 0-10v isolated dimming with 20v auxiliary output for peripherals input voltage 120 ~ 277vac input frequency 50/60hz safety ce, ul, rohs ip rating ip66 phihong technology co., ltd. 47800 fremont blvd., fremont, ca 94538 ? t: 1-510-445-0100 ? www.phihong.com/led revision 7/2/2014 electrical specifications: output power (w) output voltage (v) output current (a) tcase max (c) input current (a) input power (w) inrush current max thd (%) min power factor surge protection (kv) part number 150 0v~425v 0.35 80 1.4a@120vac 0.6a@277vac 164 30a 12 0.9 4.0 pda150w-s350g-r 150 0v~280v 0.53 pda150w-s530g-r 150 0v~210v 0.7 PDA150W-S700G-R 150 0v~140v 1.05 pda150w-s1a0g-r 150 0v~100v 1.5 pda150w-s1a5g-r 150 0v~89v 1.68 pda150w-s1a7g-r wiring diagram input, output, 0-10v dimming and auxiliary use lead-wires. lead-wires are 18awg 105c/600v solid copper. standard lead length color in. cm. black 10 25 white 10 25 blue 10 25 red 10 25 gray 10 25 violet 10 25 yellow 10 25 maximum wiring distance (at full load) wire size (awg) distance (feet) 26 8 24 13 22 21 20 34 18 54 16 85 14 137 12 210 10 357 dimming method dimming range min. output power (w) 0-10v 2%~100% 1.0 length: 241mm (9.49in) width: 59mm (2.32in) height: 39mm (1.54in) weight 1043g (2.3lbs) dimension diagram
pda150w series brand name phihong led driver description 150w, 0-10v isolated dimming with 20v auxiliary output for peripherals input voltage 120 ~ 277vac input frequency 50/60hz safety ce, ul, rohs ip rating ip66 phihong technology co., ltd. 47800 fremont blvd., fremont, ca 94538 ? t: 1-510-445-0100 ? www.phihong.com/led revision 7/2/2014 installation & application notes: section i ? physical characteristics 1.1 led driver shall be installed inside an electrical enclosure. 1.2 wiring inside electrical enclosure shall comply with 600v/105c rating or higher. section ii ? performance 2.1 led driver complies with ul standard ul8750 2.2 led driver has class a sound rating. 2.3 led driver has a minimum ambient operating temperature of -40c. 2.4 led driver has a life expectan cy of 50,000 hours at tcase of 80c. 2.5 led driver has a life expectancy of 100,000 hours at tcase of 65c. 2.6 led driver has a typical self rise of 25c at maximum load in open air without heat sink. 2.7 led driver maximum allowable case temperature is 80c ? see product label for measurement location. 2.8 led driver reduces output power to leds if max allowable case temperature is exceeded. 2.9 led driver has a failure rate of 0.01% per 1,000 hours at tcase 70c. 2.10 led driver tolerates sustained open circuit and short circuit output conditions without damage. 2.11 led driver complies with the requirements of the federal communications commission (fcc) rules and regulations, title 47 cfr part 15 non-consumer (class b). section iii ? ul conditions of acceptability (f ile e321253) when installed in the end-use equipment, the follo wing are among the considerations to be made: 3.1 the equipment shall be installed in compliance w ith the enclosure, mounting, spacing, casualty and segregation requirements of the ultimate application. 3.2 consideration should be given to measuring the temperatures on electronic components of power circuits and transformer windings when the unit is installed in the end-use equipment based upon mounting orientation, operating ambient and ventilation. 3.3 these drivers should be used within the recognized ratings. 3.4 the driver is suitable for us e in ?damp? and ?dry? locations. 3.5 the maximum available output parameters from the (0-10v) dimming circuit provided on led driver model pda150w series were tested in accordance with supplement (s b) of ul935 and was found permissible for connection via class 2 wiring. 3.6 when the drivers are installed in the end-use ap plication, the case temperature should not exceed the temperature limit specified. 3.7 the maximum measured leakage current was 0. 2ma while connected to a 277v source of supply.
pda150w series brand name phihong led driver description 150w, 0-10v isolated dimming with 20v auxiliary output for peripherals input voltage 120 ~ 277vac input frequency 50/60hz safety ce, ul, rohs ip rating ip66 phihong technology co., ltd. 47800 fremont blvd., fremont, ca 94538 ? t: 1-510-445-0100 ? www.phihong.com/led revision 7/2/2014 electrical specifications input: ac input voltage range 90vac to 305vac ac input frequency 47~63hz maximum input current 2a leakage current 0.5ma maximum at 277vac input inrush current 30a output: power factor 0.9 ripple and noise 5% of the output current efficiency (typical) 94% at 230~ 277vac 92% at 120vac turn-on delay time <1s maximum at nominal ac power on environmental: temperature operation -40 to +85c (*) non-operation -40 to +85c operating humidity 10 to 95% (*) case temperature <80c dimming function dimming control 0-10vdc dimming grounding dim(-) and vout(-) must never be connected together to ensure proper operation and is olation requirements aux grounding aux return and dim return are common emc en55015/cispr 15/fcc 47 part 15/18 class a immunity iec61000-4-2 iec61000-4-3 iec61000-4-4 iec61000-4-5 iec61000-4-6 iec61000-4-8 iec61000-4-11 iec61000-3-2 class c output over current protection the power supply will withstand continuous output overload short-circuit protection the psu will withstand a short circuit across the outputs without damage over voltage protection output is protected from no lo ad and over voltage conditions dielectric withstand (hi-pot) test primary to secondary: 4242vdc for 1 minute, 5.5ma insulation resistance primary to secondary: >5m ohm 500vdc, 1 minute lifespan 50k hours at full output power , 50c ambient, tcase <80c wire connections position terminal color specification line black awg18 solid wire neutral white awg18 solid wire ground green/yellow awg18 solid wire vout+ red awg18 solid wire vout- blue awg18 solid wire dim+ violet awg18 solid wire dim- grey awg18 solid wire aux yellow awg18 solid wire warranty 5 years
pda150w series brand name phihong led driver description 150w, 0-10v isolated dimming with 20v auxiliary output for peripherals input voltage 120 ~ 277vac input frequency 50/60hz safety ce, ul, rohs ip rating ip66 phihong technology co., ltd. 47800 fremont blvd., fremont, ca 94538 ? t: 1-510-445-0100 ? www.phihong.com/led revision 7/2/2014
pda150w series brand name phihong led driver description 150w, 0-10v isolated dimming with 20v auxiliary output for peripherals input voltage 120 ~ 277vac input frequency 50/60hz safety ce, ul, rohs ip rating ip66 phihong technology co., ltd. 47800 fremont blvd., fremont, ca 94538 ? t: 1-510-445-0100 ? www.phihong.com/led revision 7/2/2014
pda150w series brand name phihong led driver description 150w, 0-10v isolated dimming with 20v auxiliary output for peripherals input voltage 120 ~ 277vac input frequency 50/60hz safety ce, ul, rohs ip rating ip66 phihong technology co., ltd. 47800 fremont blvd., fremont, ca 94538 ? t: 1-510-445-0100 ? www.phihong.com/led revision 7/2/2014
|
